Appendix B. Calibration and Testing with PanaView
58 DigitalFlow™ XGM868i Service Manual
B.5.3i Calibration Values
To display the calibration values:
Note: If you are in the Hardware Test option, skip to step 2.
1. From the left pane of the Calibration/Test window, double-click on Hardware Test.
2. In the center pane, double-click on CALIBRATION VALUES.
3. The right pane displays a list of DAC calibration values. Click [Next Item] or [Exit Page] to return to the Hardware
Test option, and [Exit Page] again to return to the main Calibration/Test menu.
B.5.3j Programming an Optional Card EEPROM
To program the EEPROM for an optional card:
1. From the left pane of the Calibration/Test window, double-click on Hardware Test.
2. In the center pane, double-click on PROG OPCARD EEPROM.
3. To enable you to Choose an Opcard, the center pane displays a list of possible option cards. Scroll to and
double-click on the type of card installed.
4. The program asks for the Board Revision. Enter the revision letter in the right pane, and click [Next Item].
5. The next prompt asks for the Group #. Enter the appropriate value, and click [Next Item].
6. The next prompt asks for the Special Mod#. Enter the appropriate value, and click [Next Item].
7. The program now asks for the Month. Scroll to and double-click on the desired month.
8. The next prompt asks for the Day. Enter the desired value (from 1 to 31), and click [Next Item].
9. The next prompt asks for the Year. Enter the appropriate value, (from 2002 to 2089) and click [Next Item].
10. The final prompt asks for the Serial #. Enter the appropriate value, and click [Next Item].
11. The right pane now displays the programmed Header Information. When you have reviewed the data, click [Next
Item] or [Exit Page] to return to the Hardware Test option.
To Next Page
Loading...
