36 EVOLUTION SERIES E9000 MOTOR CONTROL CENTER
Spectra circuit breakers
DET-244 – Special Lugs
Power break II insulated-case circuit breakers
Trip Curves
Renewal parts
Because of the variety of components furnished in
the E9000 motor control center, the suggested
spare parts will vary. You should consider
maintaining an adequate supply of the following
components as spares:
• Overload heaters;
• Power and control circuit fuses;
• Replacement starter contact kits;
• Starter coils;
• Pilot lights;
• Push buttons;
• Circuit breakers and fusible switches;
• Extra draw-out terminal blocks;
• Complete starters and/or spare units as
warranted by installation needs.
Your account manager will be glad to assist you
in preparing a recommended parts list for your
installation.
Ordering additional or replacement parts
The following information is needed for supplying
the proper equipment:
1. All data on the motor control center
master nameplate.
2. If the unit is to be a duplicate of an existing unit,
all data on that unit’s nameplate, located on the
right side of the unit.
3. NEMA control center class: I or II.
4. NEMA wiring type: A, B or C.
5.
gasketed) 2, 3R or 12.
6. Power supply characteristics:
- Voltage
- Number of phases
- Frequency in Hz
7. Control power voltage and frequency in Hz.
8. Nameplate designation and title.
9. Motor characteristics:
- Horsepower rating;
- Speed in RPM;
-
- Full-load current in amperes;
- Accelerating time in seconds;
- Service factor.
10. Disconnect characteristics:
- Fusible switch rating (A), fuse type, and clips;
- Circuit breaker frame size and
current rating (A).
11. NEMA starter size: 1, 2, 3, 4, 5, 6 or 7.
12. Starter type: FVNR, FVR, RVNR, 2-speed winding
and accessories:
- Push buttons: start-stop, forward,
reverse, up, down;
- Transfer switch: H-O-A;
- Pilot lights: quantity, color and type;
- Interlocks: quantity of NO and NC;
- Control power transformer.
13. Unit X height or space available.
14. Are horizontal shelves or other parts required?
15. Circuitry.
16. All other modifications.
Other information
For other information, refer to the nearest ABB
sales office and give full details, including
equipment nameplate data.
Nameplates are prominently displayed on the
motor control center lineup and contain such
details as service, voltage, frequency, factory order
number. Similar nameplates are mounted on each
motor control center unit.
To Next Page
Loading...
