GE FHSD720C - Main Menu Navigation Modes; Fault List and Operator Mode

FHSD700C Series Product Guide
GE Security
5.3 Main Menu Modes
To enter one of the Main Menu Modes follow these steps:
1. Press MENU
2. Use Function UP & DOWN buttons (SCAN and ISOLATE buttons) to reach required main menu
item
3. Press ENTER (SOUNDER SILENCE button)
4. Use Value UP & DOWN buttons (RESET and ACCEPT buttons) to enter the appropriate Access
Code
5. Press ENTER
Note: Access Code Entry may be aborted by pressing the MENU button.
Note: All of the following settings can be entered using the GE Security configuration software and a
PC. This can reduce the time taken to enter certain values and parameters.
To obtain this software contact GE Security or visit the website www.gesecurity.net.
The following sections show how to enter the Main Menu Modes and what parameters are available in
each of these modes.
5.3.1 FAULTS: Fault List
Minimum Access Level Required: None
This menu item shows a list of the faults that are current in the system.
Use the Function UP & DOWN buttons (Isolate and Scan) to inspect any current fault in the list.
5.3.2 OPERATOR: Operator Mode
Minimum Access Level Required: Operator
This menu item enables the user to specifically enter Operator Mode, and permits the usage of the
Isolate, Sounder Silence and Reset buttons. Once the user has successfully entered the Operator
Access Code, the Unlock LED should activate.
20
www.gesecurity.net