FHSD700C Series Product Guide
GE Security
5.3.9 LASER CAL: Laser Calibration
Minimum Access Code Required: Level 3
This menu option is only available for factory use to calibrate the laser.
5.3.10 LOAD DEFAULTS: Load Defaults
Minimum Access Code Required: Level 2
This menu option will enable the user to reload all factory defaults for all configuration parameters under
the Configuration and Sector Alarms menus. It is recommended that the system configuration is saved
prior to applying this menu option.
5.3.11 MAINTENANCE: Maintenance Mode
Minimum Access Code Required: None
Use the Parameter UP & DOWN buttons (Isolate and Scan) to inspect any item in the maintenance list.
Table 5-8: Maintenance Parameters
Parameter Description
LASERIN Current smoke value for the laser detector output
MOD1 IN Identification number of Module 1
MOD2 IN Identification number of Module 2
MOD3 IN Identification number of Module 3
MOD4 IN Identification number of Module 4
MOD5 IN Identification number of Module 5
5.3.12 TEST OUTPUTS: Testing Mode
Minimum Access Code Required: Level 2
This menu item enables the user to manually increase or decrease smoke levels for the detector in
order to simulate a real fire event. This enables the user to test the responses of the detector to a fire
event. Please note that all alarms and relays will operate as if the system is reacting to a real fire event.
30
www.gesecurity.net
To Next Page
Loading...
