GE G60

GE Multilin G60 Generator Protection System G-3
APPENDIX G G.1 CHANGE NOTES
G
Table G–4: MAJOR UPDATES FOR G60 MANUAL REVISION Z1
PAGE
(Y3)
PAGE
(Z1)
CHANGE DESCRIPTION
--- --- Add Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
--- --- Add Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
-- -- Add Added CT failure feature to Table 2-2 Other Device Functions, to chapter 5 Settings > Control
Elements > Monitoring Elements > CT Failure Detector, and Appendix B table F124 List of
Elements as bitmask element 246 CT Failure
1-1 1-1 Add Added General Cautions and Warnings to section 1.1.1
1-5 1-5 Update Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
2-2 2-2 Add Added 50BF breaker failure to Figure 2-1 Single Line Diagram and to table
2-10 2-10 Update Updated several specifications
5-25 5-25 Add Added section 5.2.5e Routing
5-89 5-89 Update Updated Figures 5-24 and 5-25 Dual Breaker Control Scheme Logic, sheets 1 and 2
5-93 5-93 Update Updated Figure 5-26 Disconnect Switch Scheme Logic
5-280 5-280 Add Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
Table G–5: MAJOR UPDATES FOR G60 MANUAL REVISION Y3
PAGE
(Y2)
PAGE
(Y3)
CHANGE DESCRIPTION
-- xi Add Added battery disposal information as chapter 0
Table G–6: MAJOR UPDATES FOR G60 MANUAL REVISION Y2
PAGE
(Y1)
PAGE
(Y2)
CHANGE DESCRIPTION
All All Update Minor changes throughout document
All All Delete Deleted CPU options U and V
1-1 1-1 Update Updated Figure 1-1 Rear Nameplate
3-8 3-8 Update Updated Figure 3-10 Rear Terminal View
Table G–7: MAJOR UPDATES FOR G60 MANUAL REVISION Y1 (Sheet 1 of 3)
PAGE
(X2)
PAGE
(Y1)
CHANGE DESCRIPTION
All All Delete Deleted content pertaining to Ethernet switch
Title Title Update Changed part numbers. Updated address and contact information.
1-1 1-1 Update Updated address and contact information
2- 2- Add Added CPU options T, U, and V to order code table
2- 2- Delete Removed E, G, H, J, S from CPU options from order code tables
2-9 2-8 Delete Deleted 9S, 2S, 2T from replacement module order code Tables 2-7 and 2-8
2-13 2-13 Add Added Breaker Failure specifications
2-22 2-22 Update Updated Ethernet fiber table in section 2.2.9 Communications
3-10 3-10 Update Updated Figures 3-12 and 3-13 Typical Wiring Diagrams