40 /
Copyright General Electric 2011
9/23/2012
To Remove the Door
1. Remove power to the dishwasher
2. Remove Toe Kick
3. Disconnect Door Wire Harness from main control
4. Remove wire retention ties from tub, use
a pair of needle-nose pliers to aid removal.
• Tip: Inspection mirror is very helpful
5. Remove 2 - ¼” hex screws at bottom of door
6. Lock the hinges to remove Tension from Springs/Cable by
inserting a Pin (Allan Wrench, small Screwdriver etc.) at the
bottom of the hinge. Door will be open approximately 30 degrees
(similar to oven door broil stop)
7. Lift Door approximately 3 inches upward
8. Tip the top of door inward to vertical position
9. Continue lifting up to remove the door
To Next Page
Loading...
