GE GDT635HSM0SS User Manual (English)

Questions and Answers:

M
Michael RamirezSep 9, 2025
Why does my GE Dishwasher have suds in the tub?
- L
  Luke PinedaSep 9, 2025
  This is usually caused by using the wrong detergent. Use only automatic dishwasher detergents to avoid sudsing. Finish® Quantum® Automatic Dishwashing Detergent has been approved for use in all GE Appliances dishwashers. To remove suds from the tub, open the dishwasher and let suds dissipate. Pump out water by pressing Start and close the door. Wait 30 seconds. Open the door, press and hold Start for 3 seconds, and close the door. Repeat if necessary. Also, spilled rinse agent can cause suds, so always wipe up rinse agent spills immediately.
M
Max JonesAug 23, 2025
Why are my dishes not drying in my GE Dishwasher?
- P
  plopezAug 23, 2025
  Several factors can affect drying. Ensure the inlet water temperature is at least 120°F. Select Heated Dry or Dry Boost. Use Wash Temp Boost. Select a higher cycle, such as Steam Sani or Heavy. Check the rinse agent dispenser and fill as required. Additional drying time may be needed, so leave the door closed after the Clean light appears to allow the fan to run an additional 90 minutes (on some models). Note: If you open the door, this fan extension will be cancelled. If using Light cycle which uses lower water temperature and thus limited dry performance, switch to a different cycle. Allow cycles to fully complete.
M
Mrs. Jennifer FaulknerAug 25, 2025
Why does my GE GDT635HSM0SS beep once every minute?
- U
  uwilsonAug 26, 2025
  This is a reminder that your dishwasher door has been left open during operation. Press Start and close the door.
T
Thomas ThompsonAug 27, 2025
How to fix spots and filming on glasses and flatware in GE Dishwasher?
- M
  Melissa BakerAug 27, 2025
  Spots and filming can occur due to extremely hard water; use rinse agents like Finish® Jet-Dry® Rinse Aid. Ensure the inlet water temperature is at least 120°F (49°C). Avoid overloading the dishwasher and load it properly. Fresh detergent is important; use a highly rated detergent such as Finish® Quantum® Automatic Dishwashing Detergent, and refill the rinse agent dispenser with a product like Finish® Jet-Dry® Rinse Aid. Also, make sure you use the proper amount of highly rated detergent.
D
davidrasmussenAug 27, 2025
What to do if my GE Dishwasher won’t run?
- L
  Lindsey LewisAug 27, 2025
  First, check if a fuse is blown or the circuit breaker is tripped; replace the fuse or reset the breaker, and remove other appliances from the circuit. Ensure the power to the dishwasher is turned on, especially if it's controlled by a wall switch. Also, the control panel might be locked; unlock it.
T
Thomas ValdezAug 30, 2025
How to prevent cloudiness on glassware in my GE Dishwasher?
- O
  ovillarrealAug 30, 2025
  Cloudiness can result from a combination of soft water and too much detergent, leading to etching. To prevent this, use less detergent if you have soft water and wash glassware in the shortest cycle possible. Also, the water temperature entering the dishwasher exceeding 150°F (66°C) could be etching, so lower the water heater temperature.
J
Jonathan BarnesSep 13, 2025
Why does my GE GDT635HSM0SS Dishwasher's control panel lights go off when I’m setting controls?
- A
  Amanda ValenciaSep 14, 2025
  Each pad must be touched within 30 seconds of the others. To relight, touch any pad again or open the door and unlock (top control).
M
Mrs. Linda FowlerSep 12, 2025
What causes black or gray marks on dishes in my GE GDT635HSM0SS?
- C
  Christopher GomezSep 12, 2025
  These marks occur when aluminum utensils have rubbed against the dishes. Remove the marks with a mild, abrasive cleaner.
C
Crystal ReyesSep 8, 2025
Why does my GE GDT635HSM0SS Dishwasher have a long cycle time?
- E
  Erin BarrySep 8, 2025
  Longer cycles are normal as the dishwasher washes by alternating mid and lower spray arms. The turbidity sensor senses how much soil is on the dishes. Heavily soiled dish loads will add more time to the cycle. This is normal function. For best wash and dry performance, allow cycle to complete.
M
melvin61Sep 5, 2025
Why is my GE GDT635HSM0SS control panel responding to inputs but the dishwasher never filled with water?
- N
  Nicholas ShortSep 5, 2025
  Make sure the door is firmly closed. Ensure the water valve (usually located under the sink) is turned on. The flood float may be stuck. Remove the Ultra-Fine Filter assembly and lightly tap the piece under the ultra fine filter assembly that looks like a dome. Replace the filter.

GE GDT635HSM0SS Specifications

General

Type	Built-In
Color	Stainless Steel
Capacity	16 Place Settings
Control Type	Electronic
Drying System	Heated Dry
Rinse Aid Dispenser	Yes
Upper Rack Features	Adjustable
Silverware Basket	Yes
Interior Material	Stainless Steel
Energy Star Certified	Yes
Soil Sensor	Yes
Third Rack	No
Stainless Steel Tub	Yes
Dimensions (H x W x D)	34 x 24 x 24 in
Wash Arms	3
Delay Start	Yes
Wash Cycles	Normal, Heavy, Light, Rinse Only