GE GFWS1700H - Washer Component Service - Panels and Controls; Top Panel Removal and Access; Service Panel Removal and Access

– 31 –
Washer Components
Top Panel
Service Panel
WARNING: Sharp edges may be exposed when
servicing washer. Use caution to avoid injury and
wear Kevlar gloves or equivalent protection.
NOTE: Combined Phillips head/square-drive recess
screws can be utilized throughout this appliance.
Either Phillips or square-drive screwdrivers can be
used to extract or install these screws.
Removal of the top panel provides access to the
control panel, dispenser, water valve, water level
FRQWURODQGOLQH¿OWHU7KHWRSSDQHOLVKHOGLQSODFH
by a top cover and 3 screws on the back.
Top Panel Removal
1. Remove the 3 Phillips head screws that attach
the top cover, then pull the cover rearward.
NOTE: It may be helpful to place a putty knife along
the top seam between the cover and control panel,
then tap lightly rearward.
2. Slide the top panel rearward 1 inch then lift the
panel.
Rear View
Removal of the service panel provides access to
the pump cleanout, pump, tub drain hose, heater
assembly, inverter, wire junction box, front dampers,
and the door lock release ring.
Service Panel Removal
1. Remove the 3 Phillips head screws that hold the
service panel to the cabinet.
2. Pull the service panel down.
Top Panel Screws
Top Panel Screws