– 47 –
  Inverter
The inverter receives commands from the control 
board and controls motor operation.
For the inverter to operate the motor correctly 
requires a supply voltage of 120 VAC, DC input from 
the control board, and the three motor windings 
intact.
6SHFL¿FIDLOXUHVDVVRFLDWHGZLWKWKHLQYHUWHUFDQ
initiate fault codes E4A, E4B, E4C, E50, E52, and E54. 
(See the Service Test Mode section in this guide.)
To check the inverter:
1.  Remove the service panel. (See the Washer 
Components, Service Panel section in this 
guide.) 
2.  Press the 4 tabs inward and remove the junction 
box cover.
3.  Enter test mode t10, t11, or t13.
4.  Check for 120 VAC between the blue and red 
wires at the AC input harness.
NOTE: The 120 VAC inverter supply voltage is 
present only when the motor is supposed to be 
operating.
5.  Unplug washer, then check motor resistance. 
(See the Washer Components, Motor Assembly 
section in this guide.)
6.  If 120 VAC is present at the AC input harness 
and the motor resistance is correct, replace the 
inverter.
NOTE: If the inverter overheats, the washer will stop 
for 5 minutes.
The Separate Inverter
The inverter is enclosed in a protective housing and 
is located on the chassis, under the left side of the 
outer tub. It is inserted in 2 guides at the rear and 
held in place by a single Phillips head screw at the 
front.
Inverter Removal
1.  Remove the service panel. (See the Washer 
Components, Service Panel section in this 
guide.) 
2.  Press the 4 tabs inward and remove the junction 
box cover.
3.  Disconnect the AC and DC input wire harnesses 
from the inverter.
4.  Press the lock tab and remove the motor ground 
wire.
5.  Remove the plastic wire tie that holds the motor 
wiring in place.
6.  Remove the single Phillips head screw that holds 
the front leg of the inverter to the base pan.
7.  Slide the inverter rearward to clear the guides 
that hold the rear of the inverter to the chassis.
Remove the inverter through the enlarged opening 
on the left side of the front frame.
Wire Tie
Wire Harness
Wire Tie
Ground Wire
Inverter
Inverter