GE IC3645SR4W606MC2 - Page 42

DIAGNOSTIC STATUS CODES
SX TRANSISTOR CONTROL Page 42
September 2004
TRACTION
STATUS CODE
DESCRIPTION OF STATUS CAUSE OF STATUS INDICATION
-85
Motor armature current is too high, and
the control trip time is less than 1
millisecond. The key must be cycled
off and on to reset the control.
This status code will be displayed when the motor
armature current is >1600 amps in 1A mode, or
>1325 amps in control run mode.
MEMORY RECALL
YES
CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAM
Circuits valid
for
Traction
Controller
SYMPTOM
Control will not operate. The key switch
must be cycled off and on to clear the
status code.
POSSIBLE CAUSE
Defective control.
• Replace controller unit.
Shorted motor armature.
• Verify that no shorts are present in the motor
armature.
NO GRAPHIC FOR THIS
STATUS CODE
TRACTION
STATUS CODE
DESCRIPTION OF STATUS CAUSE OF STATUS INDICATION
-86
Accelerator pot values obtained during
the auto calibration routine were not
valid.
Refer to Section 8 of this manual for possible causes
of this status code.
MEMORY RECALL
NO
CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAM
Circuits valid
for
Traction
Controller
SYMPTOM
Accelerator potentiometer auto calibration
routine was not successfully completed.
POSSIBLE CAUSE:
 Misadjusted or defective accelerator
potentiometer assembly
 Verify the accelerator assembly
 Open circuit on the accelerator pedal
FU3
KEY SWITCH
P7
P1 P2P17 P6 P3 P4
START SW.
FORWARD SW.
ACC POT
L
REVERSE SW.
SEAT SW.
P5
P9
FU5
POWER CONNECTIONS
POS A1 F1
NEG A2 F2
FIELD
ARMATURE
+
-
LINE
FU1
P8