• Fasten the water valve to the cabinet by driving the
hex-head screw (13).
DO NOT DRILL ANY ADDITIONAL HOLES
NOTE: Some of the process copper tubing may
have to be moved slightly to provide clearance
for the valve.
• Check the plastic water line nut on the bottom of
the water valve to be sure it is hand tight.
DO NOT USE TOOLS.
28
Installation Instructions
REMOVE THE ACCESS COVER
Remove the rear access cover. This requires
removing six screws which attach the cover to the
back of the refrigerator case. Use a 5/16″ socket or
an adjustable wrench. Be sure to save the screws as
the access cover must be reinstalled later to ensure
your refrigerator will function properly.
1
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION
–
Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS J
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator— or
RQPNMLKJHGFC
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4″ Nutdriver
ATTACH THE WATER VALVE
• Locate the female connector plug (A).
2
• Plug the female connector (A) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
A
A
4
13
5/16″ Socket or adjustable wrench
To Next Page
Loading...
