What causes pitting on my GE Ranges cooktop?
If you notice pitting (or indentation) on your GE Ranges cooktop, it's likely due to a hot sugar mixture spilled on the cooktop. Call a qualified technician for replacement.
Why are there areas of discoloration on my GE JB645 Ranges cooktop?
Areas of discoloration on your GE Ranges cooktop can be caused by food spillovers not cleaned before the next use. Clean food spillovers promptly. Also, on models with light-colored cooktops, a hot surface may appear discolored, which is normal and temporary, disappearing as the glass cools.
How to remove scratches on my GE JB645 Ranges cooktop glass surface?
Scratches on your GE Ranges cooktop glass surface are not removable. Tiny scratches will become less visible over time as a result of cleaning. To avoid scratches, use recommended cleaning procedures and make sure the bottoms of your cookware are clean before use. Use cookware with smooth bottoms.
What does it mean when “F— and a number or letter” flash in the display of my GE JB645 Ranges?
When “F— and a number or letter” flash in the display of your GE Ranges, it indicates a function error code. Press the Cancel/Off pad and allow the oven to cool for one hour, then put the oven back into operation. If the function code repeats, disconnect all power to the oven for at least 30 seconds and then reconnect power. If the error persists, call for service.
What to do if my GE JB645 Ranges surface units do not work properly?
If your GE Ranges surface units aren't working, first check your home's fuse box or circuit breaker and replace the fuse or reset the breaker if needed. Also, ensure the cooktop controls are correctly set for the specific surface unit you're trying to use.
Why does "LOCK DOOR" flash in the display of my GE JB645?
If "LOCK DOOR" is flashing in the display of your GE Ranges, the self-clean cycle has been selected but the door is not closed. Close and latch the oven door.
Why is my GE Ranges oven not clean after a clean cycle?
Your GE Ranges oven may not be clean after a clean cycle because the oven controls were improperly set or the oven was heavily soiled. Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to self-clean again or for a longer period of time.
What to do if my GE JB645 Ranges oven door will not open after a clean cycle?
If your GE Ranges oven door will not open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool below the locking temperature.
Why does my GE JB645 surface unit stop glowing when turned to a lower setting?
When a GE Ranges surface unit stops glowing when turned to a lower setting, this is normal.
What should I do if there is excessive smoking during broiling in my GE JB645 Ranges?
If you experience excessive smoking during broiling in your GE Ranges, lower the rack position of the food, as it may be too close to the burner element.
General| Type | Freestanding |
|---|---|
| Number of Burners | 4 |
| Oven Capacity | 5.3 cu. ft. |
| Self-Cleaning | Yes |
| Color | Stainless Steel |
| Cooktop Type | Coil |
| Oven Type | Single |
| Oven Window | Yes |
| Voltage | 240 V |
| Control Type | Electronic |
| Width | 30 inches |
To Next Page
