¢tl
.£
¢tl
"G
6
i,# l
n
v
-- L
0
P_ i,#1
4b
0
0
Using the oven controls. Consomemode s;
Throughout this manual, features and appearance may vary from your model.
en Contr I
L :J L°° j LTim°rJL LJ
Tamp Rec_l[ On / Off
@ 0 @
i/7 ¢-o onq ¢ oo ,o qF to l
k Time_L Time_
oo,Io,,oolo,,
L ughtJ @:_tomot,o_eo
10
Oven Control, Clock and Timer Features and Settings
o ake/Temp Recall Pad O
Touch this pad to selectthe bake function.
Bake Light
Flasheswhile in editmode-you can changethe
oventemperature at this point. Glowswhenthe
ovenisin bake mode.
O Start/On Pad
Hust betouched to start any cookingor cleaning
function.
O isplay
Showsthe time of dag,oven temperature,
whether the oven isin the bake, broil or self-
cleaning mode and the times set for the timer
or automatic ovenoperations.The displag will
show PREwhile preheating. When the oven
reaches the selectedtemperature, the oven
control will beep and the displag will show the
oven temperature.
tf "F- and a number or letter" flashin the display and
theoven control signals, this indicatesa function error
code.
0
0
Kitchen Timer On/OFFpad
Touchthis pad to selectthe timer feature. Then
touch the + and - pads to adjust the time_
Timer Light
Flasheswhile in editmode-you can changethe
settime at this point. Glowswhenthe timer has
beenactivated.Flashesagainwhen the time has
run out untilthe control is reset.
Clock Pad
Tosetthe clock, pressthis pad twice and then
pressthe + and - pads.The time of dag will
flash in the displag when the oven isfirst
turned on.
Start Time On/Off Pad (on some models)
Usealong with the Cooking Time On/OFFor
SelfClean pads to set the oven to start and
stop automatically at a time gou set.
Start Time Light
Flasheswhile in editmode-you can changethe
starttime at this point. Glowswhen the function
hasbeen activated.
tf _lour oven was set for a timed oven operation and a
power outage occurred, the clock and all programmed
functions must be reset.
The time of day will flash in the displog when there has
been o power outage. Reset the dock.
If the function error code appears during the self-
cleaning cycle, check the oven door latch. The latch
handle ma_t have been moved, even if onl_l slightly,
from the latched position. Hake sure the latch is moved
to the right as for as it will go.
Touch the Clear/Off pad. Allow the oven to cool
for one houn Put the oven back into operation. If the
function error code repeats, disconnect the power
to the range and call for service.
0
Cooking Time On/Off Pad (on some models)
Touchthis pad and then touch the + or - pads
to set the amount of time gou want gour food
to cook.The ovenwill shut off when the cooking
time has run out.
Cooking Time Light
Flasheswhile in editmode-gou canchange the
settime at this point. Glowswhenthe function
hasbeen activated.Flashesagainwhen the time
hasrun out until the control isreset.
To Next Page
Loading...
Need help?
General
