GE JBS03 - LEVEL THE RANGE

Installation instructions
INSTALL THE RANGE
[] REPLACE THE WIRE COVER
Replace the wire cover on the range back bg
sliding its right edge under the retaining tab and
replacing the two screws removed earlier. Make
sure that no wires are pinched between the cover
and the range back.
2 screws to
replace wire,
cover
Back of range
@
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with
instructions for installation in a varietg of
locations. The instructions include all necessarg
information to complete the installation. Read
the Safety Instructions and the instructions
that fit gour situation before beginning
installation.
Tgpical installation of anti-tip bracket attachment to wall
A WARNING:
• Range must be secured bg Anti-Tip bracket
supplied.
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB2X7909.
• See instructions to install (supplied with bracket).
• Unless properlg installed, the range could be
tipped bg stepping or sitting on the doon Injurg
mag result from spilled hot liquids or from the
range itself.
[]
[]
[]
LEVEL THE RANGE
Install the oven shelves in the oven and position
the range where it will be installed.
Check for levelness bg
placing a spirit level or a
cup, partiallg filled with
water, on one of the oven
shelves. If using a spirit
level, take two readings-
with the level placed
Spirit level _
diagonallg first in one direction and then the
otheE
On all models except warming drawer
models, remove the storage drawer, broiler
drawer or kick panel. The front leveling legs can
be adjusted from the bottom and the rear legs
can be adjusted from the top. (For warming
drawer models, see Step D.)
Adjust from
the bottom
I] Lowe,
range
Front leveling legs
(on some models)
Raise
range
Adjust from the
top
Front of range
Rear leveling legs
(on some models)
J
Lower
4O