ge_com
Possible Causes What To Do
Oven temperature too Oven thermostat * Seethe Adjust the oven thermostat-Easy to do
hot or too cold needs adjustment, yourself! section.
Clockand timer do Plug on range is not completely * Hake sure electrical plug is plugged into a live,properlu
not work inserted in the electrical outlet, grounded outlet.
A fuse in your home may be * Replacefuse or reset circuit breaker
blown or the circuit breaker
tripped.
Oven controls improperly set. * Seethe Using the clock and timer section.
Display goes blank A fuse in gour home mag be * Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is turned off from * Seethe Using the clock and timer section.
showing in the display.
Ovendoor is crooked The door is out of position. * Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the
door, push down on the high corner.
Oven makes This is the sound of the • This is normal.
clicking noise heating element turning
off and on during
cooking functions.
"F--and a number You have a function error code. * Pressthe Clear/Off pad. Put the oven back
or letter"flash in into operation.
the display If the function code repeats: • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch muy have been moved, if only
slightly, from the locked position. Hake sure the latch
ismoved to the right as far as it will go. Pressthe
Clear/Off pad. Allow the oven to cool for one hour.
Put the oven back into operation.
Power outage Power outage or surge. • Somemodels will automatically resume their setting once
the power is restored.On models with a clock, you must
resetthe clock. Ifthe oven was in use,you must reset it by
pressingthe Clear/Off pad,setting the clock and
resettingany cooking function.
Display flashes Power failure.
Unable to get the display Oven control pads were not
to show "$F" pressed properly.
• Resetthe clock.
• The Bakeand Broil Hi/Lo pods must be pressed at the
some time and held for 3 seconds.
45
To Next Page
Loading...
