Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips
Consumer Support
www.GEAppliances.ca
How to Delay the Start of Cleaning
Touch the CLEAN pad.
Using the number pads, enter the
desired clean time, if a time other
than 4 hours, 20 minutes is needed.
You can change the clean time to any
time between 3 hours and 5 hours,
depending on how dirty your oven is.
Touch the START TIME pad.
Using the number pads, enter the
time of day you want the clean cycle
to start.
Touch the START pad.
The door locks automatically. The display
will show the start time. It will not be
possible to open the oven door until
the temperature drops below the lock
temperature and the LOCKED light
goes off.
When the LOCKED light goes off, you
will be able to open the door.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them
with a soap-filled steel wool pad and rinse
thoroughly with a vinegar and water
mixture.
These deposits are usually a salt residue
that cannot be removed by the clean
cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
■ You cannot set the oven for cooking or another
self-clean cycle until the oven is cool enough
for the door to unlock.
■ While the oven is self-cleaning, you can touch
the CLOCK pad to display the time of day.
To return to the clean countdown, touch the
COOK TIME pad.
■ If the racks become hard to slide, apply a small
amount of cooking oil to a paper towel and
wipe the edges of the oven racks with the
paper towel.
To Next Page
Loading...
