How to Set Your Digital Clock and Timer
Clock
The clock on your cooking center
is an accurate
solid-stite device.
CLOCK MUST BE SET
BEFORE ELECTRONIC
CONTROLS FOR LOWER
OVEN WILL WORK.
When power is first connected to
your cooking center or after a power
failure of any kind, the
digitd
display on both the microwave and
lower oven control panels shows
lighted 8’s and 18’s plus all oven
functions for about 15 seconds.
Touch the CLEAWOFF pad on the
upper touch control panel and the
microwave oven is ready to use.
How to Set the Clock
Quick Set-Clock
1. Press CLOCK pad.
2. Press number pads to enter
the time.
3. Press START pad.
Before using the lower oven, the
electronic digital clock must be
set as follows:
~m~
o
Step 1: Touch the CLOCK pad.
Step 2: Touch the number pads
the same way you read them. For
example, to set
12:34,
touch number
pads 1, 2, 3 and 4 in that order.
If number pads are not touched
within two minutes after you touch
the CLOCK pad, display reverts to
original setting. If this happens,
touch CLOCK pad and enter
numbers again.
If “PF” appears in the display,
you had a power failure. When the
power went out, the current time
was stored in the control’s
memory. Then, when the power
was restored, the time of day was
continued.
For example, after a 5-minute
power interruption, your clock will
be 5 minutes slow.
To reset the clock, touch the
CLOCK pad. “SET TIME” flashes
and the “slow” time-of-day is
displayed. Enter the correct time of
day by touching the appropriate
key pads.
To check the time of day when
display is showing other
information, simply touch the
CLOCK pad. The time of day
shows for as long as your finger
is on the pad, plus 3 additional
seconds.
To correct the time of day, touch
the CLOCK pad and enter the
correct time.
—
If you have several clocks in
your kitchen, you may wish to
blank the time of day on your
oven. If so, press and hold the
CLOCK pad, then touch the STOP
TIME pad. Although you cannot
see it, the clock maintains the
correct time of day. It will reappear
for the duration of any function
that displays a start time and stop
time.
Touching the CLOCK pad will
make the time of day reappear.
NOTE: Time of day cannot be
changed during a lower oven
cooking operation.
Then, all lights go off
and
“RESET”
appears in the upper display, and
“PF” (for Power Failure) appears
in the lower oven display.
10
To Next Page
Loading...
Need help?
General
