Appendix A: Configuration presets
Kilsen KFP-CF Series Installation Manual 61
EN 54-2 Evacuation
Configuration presets for EN 54-2 Evacuation are as follows.
Two-zone control panels
Code Zone EOL Sounder outputs Zone type
05 Passive 2 Mixed
06 Passive, CleanMe
enabled
2 Mixed
Note: CleanMe is not currently available for Kilsen detectors.
Four- and eight-zone control panels
Code Zone EOL Sounder outputs Zone type
05 Passive 4 Mixed
06 Passive, CleanMe
enabled
4 Mixed
Additional configuration characteristics are shown below.
Default sounder delay 0
Default zone delay 0n
Start/Restart sounders Start sounders or restart stopped sounders at access level 2 with or
without a fire alarm event
Inputs and outputs are as follows.
INPUT1 Remote reset
INPUT2 Delays off
OUT1 Sounder circuit
OUT2 Sounder circuit
OUT3 Sounder circuit
OUT4 Sounder circuit
Note: Two-zone control panels have only two outputs (OUT1 and OUT2).
To Next Page
Loading...
