GE Multilin L30 Line Current Differential System 5-23
5 SETTINGS 5.2 PRODUCT SETUP
5
Role — 16 bit unsigned, of type format F617
Activity Value — 16 bit unsigned
The following events are recorded in the syslog.
Table 5–3: SYSTEM EVENTS RECORDED
ENUMERATION ROLE
0 None
1 Administrator
2 Supervisor
3 Engineer
4 Operator
5Factory
ENUMERATION DESCRIPTION
1 Authentication Failed
2 User Lockout
3 FW Upgrade
4 FW Lock
5 Settings Lock
6 Settings Change. Because this can fill the entire event log, it is supported by the
already existing Settings_Change.log file. This event is not required.
7 Clear Oscillography command
8 Clear Data Logger command (not applicable to all UR products)
9 Clear Demand Records command (not applicable to all UR products)
10 Clear Energy command (not applicable to all UR products)
11 Clear Unauthorized Access command
12 Clear Teleprotection Counters command (not applicable to all UR products)
13 Clear All Relay Records command
14 Role Log in
15 Role Log off
EVENT SEVERITY DESCRIPTION
FAILED_AUTH, ORIGIN,
TIMESTAMP
Warning (4) A failed authentication with origin information (username and IP:MAC
address), a time stamp in UTC time when it occurred
AUTH_LOCKOUT, ORIGIN,
TIMESTAMP
Error (3) An authentication lockout has occurred because of too many failed
authentication attempts
FIRMWARE_UPGD, ORIGIN,
TIMESTAMP
Warning (4) Indicates that a change of firmware has occurred
FIRMWARE_LOCK, ORIGIN,
TIMESTAMP
Critical (1) An attempt was made to change firmware while the firmware lock was
enabled
SETTING_CHG, ORIGIN,
TIMESTAMP
Notice (5) Indicates setting change(s)
SETTING_LOCK, ORIGIN,
TIMESTAMP
Critical (1) An attempt was made to change settings while the settings lock was enabled
LOGIN, ORIGIN, TIMESTAMP Warning (4) Indicates when a certain role logged in
LOGOUT, ORIGIN, TIMESTAMP Notice (5) Indicates when a certain role logged out or timed out
CLEAR_OSCILLOGRAPHY Notice (5) Clear oscillography command was issued
CLEAR_DATA_LOGGER Notice (5) Clear data logger command was issued
CLEAR_DEMAND_RECS Notice (5) Clear demand records command was issued
CLEAR_ENERGY Notice (5) Clear energy command was issued
RESET_UNAUTH_ACCESS Warning (4) Reset Unauthorized access command was issued
CLEAR_TELEPROTECTION_CNT Notice (5) Clear teleprotection counters command was issued
CLEAR_ALL_RECS Warning (4) Clear all records command was issued