9
Important Note:
(1) Do not point motion sensor toward bright lights or reflective surfaces
as this will affect accuracy of the motion sensor.
(2) Avoid areas with heavy traffic or pet areas as this may trigger lights
consistently.
(3) Avoid pointing sensor directly towards severe temperature surfaces
such as heating vents, air conditioners, driveway or asphalt surfaces,
large light-colored objects that reflect heat, or other light sources. These
heat sources can generate ‘false activations’ and reduce motion sensor
distance.
5. Ensure the ‘Time’ knob is set to ‘TEST’ (rotate
counter-clockwise to left). The Dark knob is set to
the minimum position (rotate counter-clockwise
to left). In this ‘TEST’ mode, the lights will turn on
for 5 seconds after motion is detected and then
turn off. In the ‘TEST’ mode, the lights will turn
on during daylight.
6. To test motion activation coverage, walk
through detection area noting your position when the lights turn on. To
increase the coverage area, raise the motion sensor up slightly. To reduce
the coverage area, position the sensor downward slightly. Once optimum
coverage set, tighten lock nut and adjustment knob until snug. Do not over-
tighten.
7. Once you have completed the test set-up, adjust the ‘Time’ setting from
‘Test’ position from 1 to 10 minutes as desired. When out of ‘TEST’ mode, the
LEDs lights will not turn on during daylight hours when motion is detected.
Time
TEST
MAX
MAX
Dark
To Next Page
Loading...
