There are three main requirements for installing the transceiver: ade-
quate and stable primary power, a good antenna system, and the cor-
rect data connections between the transceiver and the data device.
Figure 3 shows a typical remote station arrangement. This is followed
by step-by-step procedures for installing the transceiver and making
external connections.
Table 1. Accessories Supplied with the Unit
Accessory Description Part Number
DC Power Plug,
2-pin, polarized
Mates with power connector on radio.
Screw terminals provided for wires,
threaded locking screws to prevent
accidental disconnect.
73-1194A39
Radio
Configuration
Software
PC software used for setting the basic
operating parameters of the radio.
03-3156A01
Start-Up Guide Brief instructions for initial setup and
commissioning of the radio.
05-4669A01
Reference
Manual
Full technical information for the
radio, including a complete
description of software commands.
05-4670A01
To Next Page
Loading...
