MDS 05-7280A01, Rev. A MDS TransNEXT Technical Manual 25
Configuration
The “Configuration” page allows a Web UI user to change device configuration using the same parameter
syntax visible in the CLI.
To effect a change, move the scrollbar on the right to the appropriate configuration group (com1, radio,
etc.) Next, find the specific attribute in the group to modify. The attribute’s current value is shown
immediately to the right of the colon. Click on the value after the colon to edit it. If multiple changes
are desired, repeat the process above. To save the configuration and cause the new settings to go into
effect, click the “Save” button on the bottom left.
To Next Page
Loading...