NX-590E Internet Interface
12
Segment 1 Alarms and Restores Segment 9 Tampers
Segment 2 Open/Close Segment 10
Short Circuit & Ground Fault
Segment 3 Bypass Segment 11
Sensor Lost
Segment 4 Zone Trouble Segment 12
Sensor Low Battery
Segment 5 Power Trouble (AC Failure or
Low Battery)
Segment 13
Expander Trouble
Segment 6 Siren & Telephone Fault Segment 14
Failure To Communicate
Segment 7 Test Reports Segment 15
Zone Activity Monitor
Segment 8 Program, Download & Log Full Segment 16
Reserved
L
OCATION 2 PROGRAMMING PARTITIONS TO REPORT VIA INTERNET TO RECEIVER #2 (16
SEGMENTS OF FEATURE SELECTION DATA)
Location 2 contains the partition(s) that should be included when reporting over the Network to
Receiver #2. If you wish to exclude any partition from reporting, simply turn off the LED
corresponding to that particular partition. If the partition LED is off, no event from that partition
will report via network regardless of what is programmed elsewhere. Using Table 10-1 on page
11, enter the corresponding number of the partition(s) to include for each type of report found in
Segments 1 –16. Factory default is all partitions off.
Segment 1 Alarms and Restores Segment 9 Tampers
Segment 2 Open/Close Segment 10
Short Circuit & Ground Fault
Segment 3 Bypass Segment 11
Sensor Lost
Segment 4 Zone Trouble Segment 12
Sensor Low Battery
Segment 5 Power Trouble (AC Failure or
Low Battery)
Segment 13
Expander Trouble
Segment 6 Siren & Telephone Fault Segment 14
Failure To Communicate
Segment 7 Test Reports Segment 15
Zone Activity Monitor
Segment 8 Program, Download & Log Full Segment 16
Reserved
L
OCATION 3 PROGRAMMING THE PARTITIONS REPORTING VIA EMAIL ACCOUNT #1 (16 SEGMENTS
OF
FEATURE SELECTION DATA)
Location 3 contains the partition(s) that should be included when reporting over the Internet to
Email Account #1. If you wish to exclude any partition from reporting, simply turn off the LED
corresponding to that particular partition. If the partition LED is not on, NO event from that
partition will report via network regardless of what is programmed elsewhere. Use Table 10-1 on
page 11 to program which partitions to report for Segments 1–16. Factory default is all
partitions off.
Segment 1 Alarms and Restores Segment 9 Tampers
Segment 2 Open/Close Segment 10
Short Circuit & Ground
Fault
Segment 3 Bypass Segment 11
Sensor Lost
Segment 4 Zone Trouble Segment 12
Sensor Low Battery
Segment 5 Power Trouble (AC Failure or
Low Battery)
Segment 13
Expander Trouble
Segment 6 Siren & Telephone Fault Segment 14
Failure To Communicate
Segment 7 Test Reports Segment 15
Zone Activity Monitor
Segment 8 Program, Download & Log Full Segment 16
Reserved
To Next Page
Loading...
