NX-590E Internet Interface
15
L
OCATION 60 SIA OR CONTACT ID ACCOUNT NUMBER (16 SEGMENTS HEX DATA)
This location contains the SIA or Contact ID account number. Contact your usual source of
account number and dial number for installations.
It is important to add leading zeros to create a 16-digit number.
L
OCATION 61 PHONE LINE RECEIVER NUMBER (4 SEGMENTS DECIMAL DATA)
This location contains the phone line receiver number associated with this account. Contact your
usual source of account number and dial number for installations.
L
OCATION 62 LINE NUMBER (4 SEGMENTS DECIMAL DATA)
This location contains the line number associated with this account. Contact your usual source
of account number and dial number for installations. If you have a Sure-Gard receiver with line
A, enter as line 11.
L
OCATION 63 TIMERS AND COUNTERS (3 SEGMENTS DECIMAL DATA)
This location sets the number of attempts and the number of seconds to access the network.
Ordinarily, these segments should not be changed. The defaults are balanced to provide a
number of network attempts that satisfy UL requirement if the alarm must be dialed back. The
unit will make the number of attempts in Segment 1 until the number of seconds in Segment 2 is
exhausted. If UL Polling is turned on, the time is this number plus 30 seconds. The default will
yield a polling time of less than 90 seconds under most conditions.
Segment 1 Number of network attempts (Factory default is 2)
Segment 2 Time in seconds for overall network attempt
(
Minimum 30 seconds. Factory default is 30)
Segment 3 Polling time in seconds (Factory default is 10)
L
OCATIONS 63 - 94 RESERVED
To Next Page
Loading...
