GE NX-4-EUR

Communicator codes for slow speed formats only
LOCATIONS 56-83 ARE ONLY USED WHEN REPORTING EVENTS TO A PAGER, OR WHEN USING A
SLOW FORMAT SUCH AS 4+2. WHEN USING CONTACT ID OR SIA, THERE IS NO NEED TO
PROGRAM THESE LOCATIONS.
LOCATION 56 - ALARM/RESTORE COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments, numerical
data)
Location 56 contains the event code for any zone “Alarm” and “Restore” for a 4+2 and 3+1
format. For a 4+2 format, the digit programmed in this location will be sent as the tens digit of
the alarm event code. As ones digit, the zone number (1-8) will be reported (e.g. zone 1 = 1,
zone 8 = 8).
This location contains 8 segments but only segment 1 and 5 are used.
Segment 1 contains the alarm code for zone 1 to 8.
Segment 5 contains the restore code for zone 1 to 8.
Segment 1
Zones 1-8, “Alarm Code”
Segment 2-4
Reserved
Segment 5
Zones 1-8, “Restore Code”
Segment 6-8
Reserved
LOCATION 57 - BYPASS COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments, numerical data)
Location 57 contains the event code for a zone “Bypass” with a 4+2 and 3+1 format. For a 4+2
format, the digit programmed in this location will be sent as the tens digit. As ones digit, the
zone number (1-8) will be reported (e.g. zone 1 = 1, zone 8 = 8).
When unbypassing a zone, the restore code of location 56 will be used.
Segment 1
Zones 1-8, “Bypass Code”
Segment 2-8
Reserved
LOCATION 58 - TAMPER COMMUNICATOR CODE, SLOW SPEED FORMATS (8 segments, numerical data)
Location 58 contains the event code for a zone “Tamper” with a 4+2 and 3+1 format. For a 4+2
format, the digit programmed in this location will be sent as the tens digit. As ones digit, the
zone number (1-8) will be reported (e.g. zone 1 = 1, zone 8 = 8).
To report a restore, the restore code of location 56 will be used.
Segment 1
Zones 1-15, “Tamper Code”
Segment 2-8
Reserved
NX-4-EUR Installation manual Page 57 02/07/06