GE P54B - Page 596

Appendix B - Settings and Signals
P54A/B/C/E
B30
P54xMED-TM-EN-1
MENU TEXT COL ROW DEFAULT SETTING AVAILABLE OPTIONS
DESCRIPTION
Abort
[Indexed String]
Saves all IED settings.
Copy From 09 05 Group 1
Group 1
Group 2
Group 3
Group 4
[Indexed String]
Allows displayed settings to be copied from a selected setting group
Copy To 09 06 No Operation
No Operation
Group 1
Group 2
Group 3
Group 4
[Indexed String]
Allows displayed settings to be copied to a selected setting group
Setting Group 1 09 07 Enabled
Disabled
Enabled
[Indexed String]
Settings Group 1. If the setting group is disabled from the configuration, then all associated settings and signals are hidden, with the
exception of this setting.
Setting Group 2 09 08 Disabled
Disabled
Enabled
[Indexed String]
Settings Group 2. If the setting group is disabled from the configuration, then all associated settings and signals are hidden, with the
exception of this setting.
Setting Group 3 09 09 Disabled
Disabled
Enabled
[Indexed String]
Settings Group 3. If the setting group is disabled from the configuration, then all associated settings and signals are hidden, with the
exception of this setting.
Setting Group 4 09 0A Disabled
Disabled
Enabled
[Indexed String]
Settings Group 4. If the setting group is disabled from the configuration, then all associated settings and signals are hidden, with the
exception of this setting.
Tripping Mode 09 0E 3 Pole
3 Pole
1 and 3 Pole
[Indexed String]
Current Diff 09 0F Enabled
Disabled
Enabled
[Indexed String]
To enable (activate) or disable (turn off) the Differential Protection: ANSI 87.
To get the differential protection fully active, it is necessary also to enable the differential protection in the group. Note that Phase Diff
setting and InterMiCOM64 Fiber setting are mutually exclusive as with Phase Diff enabled, the digital message exchanged has the structure
of the differential message (i.e. currents are sent to the remote end, etc) and with interMiCOM64 Fiber the digital message exchanged has
the structure and properties of the InterMiCOM64 Fiber.
Overcurrent 09 10 Disabled
Disabled
Enabled
[Indexed String]
To enable (activate) or disable (turn off) the Phase Overcurrent Protection function. I> stages: ANSI 50/51/67
Neg Sequence O/C 09 11 Disabled
Disabled
Enabled
[Indexed String]
To enable (activate) or disable (turn off) the Negative Sequence Overcurrent Protection function. I2> stages: ANSI 46/67
Broken Conductor 09 12 Disabled
Disabled
Enabled
[Indexed String]
To enable (activate) or disable (turn off) the Broken Conductor function. I2/I1> stage: ANSI 46
Earth Fault
09
13
Disabled
Disabled