What to do if GE PB930 Ranges surface units do not work properly?
If the surface units on your GE Ranges aren't working properly, first check if a fuse in your home has blown or the circuit breaker has tripped and replace the fuse or reset the circuit breaker. Also, ensure that the cooktop controls are correctly set for the surface unit you're using.
Why "LOCK DOOR" flashes in the display of my GE Ranges?
If "LOCK DOOR" is flashing in the display of your GE Ranges, it means the self-clean cycle has been selected but the door is not closed. Close the oven door.
What to do if DOOR LOCK light is on when you want to cook with GE PB930?
If the DOOR LOCK light is on when you want to cook with your GE Ranges, the oven door is locked because the temperature inside the oven has not dropped below the locking temperature. Press the Cancel/Off pad and allow the oven to cool.
How to reset clock on GE PB930 Ranges after power outage?
After a power outage or surge, if the clock on your GE Ranges flashes, reset the clock. If the oven was in use, you must reset it by pressing the Cancel/Off pad, setting the clock, and resetting any cooking function.
What to do if food does not bake properly in GE PB930 Ranges?
If food isn't baking properly in your GE Ranges, several factors could be at play. Ensure the oven controls are set correctly. Also, check that the rack position is correct and level. Incorrect cookware or the wrong size can also cause issues, as can an oven temperature that needs adjustment. Finally, ingredient substitutions can alter the outcome.
Why is my GE Ranges oven temperature too hot or too cold?
If your GE Ranges oven temperature is too hot or too cold, it may need adjustment. Please refer to the Special Features section.
What to do with excessive smoking during GE PB930 Ranges clean cycle?
If there's excessive smoking during the clean cycle of your GE Ranges, it's likely due to excessive soil or grease. Press the Cancel/Off pad, open windows to clear the smoke, and wait for the LOCKED light to turn off. Wipe up the excess soil, then reset the clean cycle.
Why GE PB930 surface units are cycling off and on frequently?
If the surface units on your GE Ranges are frequently cycling off and on, it may be due to improper cookware. Use only flat cookware to minimize cycling.
Why does “LOCK DOOR” flash in the display of my GE Ranges?
If “LOCK DOOR” is flashing on your GE Ranges display, it means the self-clean cycle has been selected, but the oven door isn't fully closed. Make sure to close the oven door.
Why my GE Ranges oven does not work?
If your GE Ranges oven isn't working, there might be a blown fuse or a tripped circuit breaker in your home. Replace the fuse or reset the circuit breaker. It's also possible that the oven controls are not set correctly. Please refer to the Using the Oven section for instructions.
To Next Page
General
