GE PDT660SSF2SS - Materials You will Need; Tools You will Need

TOOLS YOU WILL NEED:
• Phillips-head screwdriver
• 1/4" and 5/16" nutdriver
•
• Level
• Carpenter's square
• Measuring tape
• Safety glasses
• Flashlight
•
• 15/16" socket (optional for skid removal)
• Gloves
• Pliers
For New Installations Only:
• Tubing cutter
• Drill and appropriate bits
• Hole saw set
Hot Water Line
Hole Saw Set
Level
Strain Relief
Drain Hose
Hose Clamp
1/4" and 5/16"
Nutdriver
15/16" Socket
Bucket
Tubing Cutter
Drill and Bits
Flashlight
Gloves
Phillips-Head
Screwdriver
Carpenter's
Square
6"
Adjustable
Wrench
Safety Glasses
Pliers
Installation Preparation
2
Measuring Tape
PARTS SUPPLIED
IN INSTALLATION PACKAGE:
• Hose clamp, drain hose, plug buttons
• 2 mounting brackets for wood countertops or side
• 4 flat head wood screws
MATERIALS YOU WILL NEED:
• 90° elbow (3/4"hose internal thread on one end,
opposite end sized to fit water supply)
• UL-listed wire nuts (3)
• Masking Tape
Materials Needed for New Installations:
• Air gap for drain hose, if required
• Waste tee for house plumbing, if applicable
• Electrical cable
• Screw-type hose clamps
• Strain relief for electrical connection
• Hand shut-off valve (recommended)
• Hot Water Line–3/8" minimum, copper tubing
(including ferrule, compression nut).
Hose Clamps
Waste Tee
Electrical Cable
Wire Nuts (3)
Mounting
Brackets
Literature
90°Elbow
Coupler for
optional drain
hose
Hand
Valve
Air Gap
Plug Buttons
Masking Tape
(if applicable)
4 Wood Screws
• Literature, samples and/or coupons