Dimensions and Installation Information (in inches)
For answers to your Monogram,
®
Cafe
™
Series,
Profile
™
Series or GE
®
appliance questions, visit
our website at geappliances.com or call GE
Answer Center
®
service, 800.626.2000.
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
" MAX.
23-3/4"
29-7/8"
27-1/2"
4"(toekick)
Includes 3/4" custom panel
PDT750SSF
GE
®
Stainless Steel Interior Dishwasher with Hidden Controls
Specification Revised 8/13
350293
Listed by
Underwriters
Laboratories
• The rough cabinet opening must be at least 24" deep, 24"
wide and approximately 34-1/2" high from floor to underside
of the countertop.
24"
Min.
This Wall Area
must be Free
of Pipes or
wires
Plumbing and Electric Service
Must Enter Inside This Area
4"
24"
Min.
6"
Cabinets
Square
and
Plumb
+
34-1/2" 1/4"
Underside of
Countertop
to Floor
Figure A
33-1/2” to 34-3/4”
Underside of
Countertop
to Floor
Electrical Rating
Voltage AC.......................................................... 120
Hertz..................................................................... 60
Total connected load amperage............ 9.9
Calrod
®
heater watts max..................... 1000
For use on adequately wired 120-volt,
15-amp circuit having 2-wire service
with a separate ground wire. This appliance
must be grounded for safe operation.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
†† Add 1/2" for deepest part of contour door.
Allow an additional 2” for the handle on
PDWT500/PDWT400/PDWT200 Series
models.
To Next Page
Need help?
General
Weight and Dimensions
