– 14 –
Remove the 1/4-in. hex-head screw from the 2.
inside of each railing.
Screw
Lift up on both sides of the freezer drawer 3.
handle to separate the drawer railings from the
rail assemblies.
Set the drawer front on a non-scratching 4.
surface and push the rail assemblies back into
locking position.
Rail Assembly
Drawer
Assembly
To replace the freezer drawer:
Note: Two people may be required to complete this
procedure.
Pull out the rail assemblies to their full length on 1.
each side of the cabinet.
Locate the slots on the inside of the rail 2.
assemblies near the back.
3. Insert the hooks at the back of the drawer
railings into the slots on the rail assemblies.
4. Lower the front of the drawer, making sure the
tabs on the sides of the railings fi t into the front
slots in the rail assemblies.
Replace the screw on each rail assembly and 5.
replace the freezer basket by lowering it into the
frame.
Slot
Rail assembly
Slot
Tab
Hook
Removing the Freezer Drawer
To remove the freezer drawer:
Open the freezer drawer until it stops. Lift up on 1.
the back of the basket and lift the basket out of
the drawer.
To Next Page
Loading...
Need help?
General
