1
Installation
30″ Induction Cooktop
Instructions
PHP900, ZHU30
31-10667 (06-07 JR)
TOOLS YOU WILL NEED
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•
IMPORTANT — Save these instructions
for local inspector’s use.
•
IMPORTANT — Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Product failure due to improper installation is
not covered under the Warranty.
WARNING — This appliance must be
properly grounded.
•
ATTENTION INSTALLER — ALL
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX.
A “PLUG AND RECEPTACLE” IS NOT PERMITTED
ON THESE PRODUCTS.
• Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
Saber Saw
Pencil
Safety Glasses
1/8″ Drill Bit & Electric or
Hand Drill
Ruler or Straightedge
Phillips Head
Screwdriver
“If you have questions, call 800.GE.CARES or visit our website at: ge.com”
“In Canada, call 800.561.3344 or visit our website at: geappliances.ca”
1/4″ Nut Driver
MATERIALS YOU WILL NEED
Large Size
Wire Nuts
Junction Box
(Sized for conduit
per local electrical
codes.)
3/4” Strain Relief
PARTS INCLUDED
Baffle
(For all installations
except over an oven.)
2 Hold-Down Brackets
6 Hex-Head Screws
2 Thumbscrews
Foam Tape
To Next Page
Need help?
General
