Why does my GE Water Filtration System control regenerate at the wrong time of day?
If the GE Water Filtration System control regenerates at the wrong time of day, it's likely due to an incorrect setting. You should correct the time setting according to the provided instructions.
What does Err 6 mean on my GE Pro Elite 268-716-150-1248 Water Filtration Systems and how do I fix it?
If the GE Water Filtration System displays Err 6, the probe may be defective or disconnected. Replace or reconnect the probe.
What does ERR 2 mean on GE Pro Elite 268-716-150-1248 Water Filtration Systems?
If the GE Water Filtration System displays ERR 2, the control is not a “North American” 60 Hz model. Install a 60 Hz Analyzer control.
What causes a regenerant tank overflow in GE Pro Elite 268-716-150-1248 Water Filtration Systems and how can I fix it?
If you experience a regenerant tank overflow in your GE Water Filtration Systems, it can be due to: * Uncontrolled refill flow rate: Remove the refill flow control to clean the ball and seat. * Air leak in the regenerant line: Check all connections in the regenerant line for leaks. * Drain control clogged: Clean the drain control.
General| Brand | GE |
|---|---|
| Filter Type | Carbon Block |
| Filter Life (Months) | 6 |
| NSF Certified | Yes |
| Model | 268-716-150-1248 |
| NSF Standards | 42 |
| Product Type | Under Sink Water Filtration System |
Crucial safety precautions and warnings for installation and operation of the water conditioning system.
Instructions for connecting the water lines and installing the bypass valve system.
Information on AC adapters, power supply requirements, and potential power interruption effects on settings.
Explains how the system operates, including water flow during service and regeneration cycles.
Outlines the steps for programming the control for normal applications, including key settings.
Details on adjusting Level II parameters for fine-tuning conditioner operation.
Steps for starting the 268 water conditioning system, filling the brine tank last.
Steps for starting the 268r water conditioning system, filling the brine tank first.
Lists common error codes for the Analyzer control and their corresponding causes and solutions.
Provides solutions for common system problems like regenerant tank overflow and water leakage.
To Next Page
