GE Profile DPSR610EG User Manual

For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
270192
DPSR610EG
GE Profile
™
7.0 Cu. Ft. Super Capacity Electric Dryer with Stainless Steel Drum
Listed by
Underwriters
Laboratories
36
25-1/2
42
51
Side View
27
Rear View
36
42
27
2
3-1/2
2-1/2
25-1/2*
Side View
Rear View
8-1/2
28-1/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
Washer/Dryers SC QSart
5.7 cu. ft. Dryers
2
Back View
Power
Cord Hole
30-1/2
5.8, 6.0 and 7.0 cu. ft. Dryers
5
Back View
Power
Cord Hole
4-1/2
Power Cord Locations
Electric Dryer Rating:
240V
5600W 24A 60Hz
208V
4400W 22A 60Hz
Exhaust Option: 4-way rear, right, left
and bottom
Circuit Requirements: An individual,
properly-grounded branch circuit, protected
by a 30-amp circuit breaker or a time-delay
fuse, is required.
Note: Dryer wall outlet must be located within
36" of service cord entry and acessible when
dryer is mounted in position.
Installation Information: For complete
information, see installation instructions
packed with your dryer.
Dimensions and Installation Information (in inches)
Specification Revised 5/09

GE Profile DPSR610EG Specifications

General

Brand	GE Profile
Model	DPSR610EG
Type	Electric Dryer
Capacity	7.0 cu. ft.
Color	White
Dryer Venting	Vented
Number of Temperature Settings	4
Wrinkle Care Option	Yes
Moisture Sensor	Yes
Energy Star Certified	No
Width	27 inches
Control Type	Electronic
Weight	120 lbs

Summary

Dimensions and Installation Information

Electric Dryer Rating

Specifies the electrical ratings for 240V and 208V operation, including wattage, amperage, and frequency.

Exhaust Option

Details the available exhaust vent directions: rear, right, left, and bottom.

Circuit Requirements

Requires an individual, properly-grounded branch circuit protected by a 30-amp breaker or time-delay fuse.

Installation Notes

Important notes regarding dryer wall outlet location and accessibility for installation.

Ducting Materials and Exhaust

Ducting Materials

Recommends 4" diameter all rigid metal exhaust duct for best performance; specifies UL-listed flexible metal duct usage.

Exhaust Length Calculation

Guidance on calculating maximum rigid duct length based on 90° turns and dryer model.

Special Installation Requirements

Covers alcove, closet, bathroom, and bedroom installation clearances and ventilation needs.

Dryer Exhausting Information

Specifies using metal duct only and provides a chart for best performance based on turns and hood type.

Features and Benefits

Capacity and Drum

Highlights 7.0 cu. ft. Super Capacity and Stainless Steel Drum for durability and garment care.

Drying Performance

Details Four Heat Selections, 10 Dry Cycles, and Sensor Dry for optimized drying and fabric protection.

Convenience Features

Includes On/Off End-of-Cycle Signal, Interior Dryer Light, and Rotary Electronic Controls.

Specific Cycles

Features Delicate (Low Heat) Cycle for heat-sensitive fabrics like microfiber and rayon/nylon.