ā 26 ā
To remove the upper oven door assembly on
PS978:
Caution: The door is heavy. Use the correct lifting
procedure. Do not lift the door by the handle.
1. Open the door fully.
2. Lift each hinge lock towards the oven frame
until it stops.
Hinge Lock
5. Lift the door up until it is clear of the door
hinges.
6. Pull on the hinge arms lightly to relieve pressure
on the locking tabs.
7. Push the hinge locks down onto the hinge.
8. Push the hinges in toward the unit so they are
closed.
To replace the upper oven door assembly on
PS978:
1. Pull the hinges down away from the oven frame
to the fully open position.
2. Lift up on the hinge locks and rotate toward the
oven frame until they stop.
3. The hinges will release to the 45-degree position.
The hinge locks will contact the oven frame.
4. Slide the door back onto the hinges. Make sure
the buttons pop back out.
5. Fully open the door.
6. Rotate the hinge locks back toward the door
and onto the hinge.
7. Close the oven door.
3. Close the door to the stop position. The hinge
locks will contact the oven frame.
4. Simultaneously press down on each release
button located on the top of both hinges.
To remove the outer door assembly of the upper
oven door on PS978:
1. Remove the door. (See To remove the upper
oven door assembly on PS978, this section.)
2. Place the door assembly gasket side down on a
protective surface.
3. Remove the two T-15 Torx screws that attach
the bottom of the outer door assembly to the
outer door.
Release
Button
(Continued next page)
To Next Page
Loading...
