– 25 –
6. Slide the bottom trim and the glass out of the
outer door frame.
Note: Two arrows on the glass indicate the correct
orientation of the glass when it is installed. The side
with the arrows is to be placed facing the outside of
the frame with arrows pointing toward the top.
To replace the outer door assembly on PS978:
Remove the four 1/4-in. hex-head screws that hold
the inner heat shield and door handle to the outer
door assembly.
Caution:
• Care must be taken if reinstalling the door
handle. Be sure that each handle cushion is
placed between the glass and the bracket.
• Overtightening screws can damage handle/
glass. Hand-tighten screws and make sure
handle fi ts snugly to door panel. (Do not use
electric driver.)
Handle Cushion
(Continued next page)
To Next Page
Loading...
