– 24 –
To replace the outer door assembly on PHS925:
1. Remove the inner door assembly. (See To
remove the inner door assembly, this section.)
2. Remove the two 1/4-in. hex-head screws from
the heat defl ector.
3. Lower the heat defl ector to fully expose the 2
screws that attach the handle and top trim to
the outer door frame.
4. Remove the two 1/4-in. hex-head screws that
attach the handle and top trim.
Note: When installing the door handle, make sure
the handle is level with the top of the door before
attaching the heat defl ector. An enlarged hole for
the right side screw has been provided for this
adjustment.
5. Remove the three 1/4-in. hex-head screws (3
from each side) that attach the bottom trim to
the outer door frame.
Bottom Center Clip
On PS978, make sure the gasket is cross tucked in
the bottom slots of the inner door panel. Use a small
screwdriver to tuck the loose ends of the gasket into
the slots. The overlap is required to ensure a proper
door seal.
Cross Tuck
On PHS925, the bottom center clip joins both ends
of the gasket to form a continuous seal. Make sure
this clip is inserted into the bottom center hole in the
inner door panel.
(Continued next page)
To Next Page
Loading...
