– 23 –
4. Remove the six 1/4-in. hex-head screws that
attach the heat barrier to the inner door.
Remove the heat barrier.
5. Remove the insulation and the inner glass
assembly from the inner door.
Air enters the door assembly through large slots in
the bottom and fl ows upward between the inner
and outer assemblies, exhausting through slots
in the top of the door. DO NOT INSULATE THIS AIR
CHANNEL.
Arrows on the top of the inner glass assembly
indicate the direction that the inner oven door glass
is installed. The arrows should be pointing toward
the oven cavity.
OVEN
Inner Glass Assembly
Door Gasket
The door gasket forms a seal around the front edge
of the oven liner and the inner door panel. The door
gasket is attached to the inner door panel by spring
clips. When removing the gasket, place a fi nger
under the gasket beside each clip and pull straight
up.
When installing the door gasket, it is helpful to fold
the gasket in half and locate the top center clip.
Insert the clip at the top of the door and work your
way around the door.
Assembly Notes
When assembling, make sure the hinges are parallel
to each other and perpendicular to the door liner. If
not, the hinge may bind on the receiving channel of
the door. If the new hinge is not in the cocked and
locked position after installing, place the bottom of
the door against a fi rm, protected surface and push
the hinge arm down to the cocked position. Pull the
hinge lock back against the door liner surface to
lock the hinge in this position.
(Continued next page)
To Next Page
Loading...
