GE Profile HE Washer (3/3/08)
GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURE
Copyright 2008 General Electric Company
12
g
GE imagination at work
Test 3 – 5 Step Water Valve and
Dispenser Check
• The display shall initially show “t3”. When the water level increases the display will also increase
• Start button pressed 1 time – The Display will toggle between “A” and the water level. The Cold
Valve will be energized and dispense water through the Detergent dispenser and remain this way
until the Start or Cycle button is pressed.
• Start button pressed a 2nd time - The Display will toggle between “b” and the water level. The
Hot Valve will be energized and remain this way until the Start or Cycle button is pressed.
• Start button is pressed a 3rd time - The Display will toggle between “c” and the water level.
The control will turn on the Hot Valve and dispense water through the Pretreat Dispenser and will
remain this way until the Start or Cycle button is pressed.
• Start button is pressed a 4th time - The Display will toggle between “d” and the water level. The
control will turn on the Cold Valve and dispense water through the Bleach Dispenser. This will
remain this way until the Start or Cycle button is pressed.
• Start button is pressed a 5th time - The Display will toggle between “E” and the water level.
The control will turn on the Cold Valve and dispense water through the Softener Dispenser. This
will remain this way until the Start or Cycle button is pressed. When Start button is pressed,
returns to “t3”. When Cycle button is pressed, exit the test and advance to next test “t4”.
• In every step washer control should monitor the water level. When the water level reaches level 7
washer control will turn off the water valve. Then exit the test to “t3”. (Control should ignore the
start button at this time in Test 3.)
To Next Page
Loading...
Need help?
General