Page 4 Protimeter MMS Moisture Measurement System
1.1 Switching the MMS ON and OFF
Prior to initial use, ensure that two AA batteries are correctly inserted in the
battery compartment.
Note: Low battery power is indicated by on the display; when this
symbol appears, replace the batteries.
Switch the MMS ON by pressing momentarily.
The MMS switches OFF automatically after 1 minute, unless the default setup
is changed (see section 2.5 for instructions). To switch the instrument OFF
immediately, press and hold for at least 3 seconds. Once has been
depressed for 3 seconds or more, all text blocks appear on the display; when
is released, the text blocks disappear and the unit switches OFF.
1.2 Optional Accessories
A range of optional accessories may be used with the Protimeter MMS. These
include:
• hammer electrodes
• data download software & cable
• additional Hygrosticks and Humisticks
For more information please contact GE Sensing.
2 Moisture Meter Modes
The Protimeter MMS can be used to detect and measure moisture in non-
conductive solid materials such as wood, drywall and masonry. Two modes of
operation are available, the Search Mode for qualitative measurements and the
Measure Mode for precise and localized moisture content measurements in
wood or WME values in materials other than wood.
!
To Next Page
Loading...
