To Next PageTo Next Page
Need help?Do you have a question about the GE PQMII and is the answer not in the manual?
General| Type | Power Quality Meter |
|---|---|
| Sampling Rate | 256 samples/cycle |
| Flicker Measurement | Pst, Plt |
| Power Measurement | Active, Reactive, Apparent Power, Power Factor |
| Voltage Channels | 3 or 4 (3-phase + neutral) |
| Current Channels | 3 or 4 (3-phase + neutral) |
| Transient Capture | Yes |
| Data Logging | Yes |
| Communication Interfaces | Ethernet, USB |
| Operating Temperature | -10°C to +50°C |
| Humidity | 5-95% non-condensing |
Covers EnerVista software for PQMII configuration and management.
Details external connections, wiring diagrams, and electrical setup.
Explains control power, VT/CT inputs, and analog/switch I/O setup.
Details configuration for RS485 and RS232 serial communication ports.
Details how to use the keypad for setpoint entry and navigation.
Procedure for updating the PQMII's firmware via software.
Guide to using the EnerVista software for setpoint entry and data.
Covers general PQMII settings like preferences, access, and ports.
Details configuration for current, voltage, analog I/O, and pulse settings.
Explains the setup for alarm and auxiliary output relays.
Covers configuration of alarms for current, voltage, frequency, and power.
Displays current, voltage, power, energy, demand, and frequency measurements.
Presents power quality metrics like crest factor, THD, data logger, and events.
