GE PQMII - Default Message Sequence

CHAPTER 3: OPERATION
PQMII POWER QUALITY METER – INSTRUCTION MANUAL 3–9
3.4.4 Default Message Sequence
Each PQMII is pre-programmed with five default messages as shown below. Note, each
time the factory setpoints are reloaded the user programmed default messages are
overwritten with these messages.
The PQMII will scroll through the default messages in the sequence shown.
THREE PHASE REAL
POWER = 1000 kW
TO DELETE THIS
MESSAGE PRESS ENTER
DEFAULT MESSAGE
REMOVED
ACTUAL VALUE OR SETPOINT
TO BE REMOVED FROM THE
DEFAULT MESSAGE QUEUE
DISPLAYED FOR 3 SECONDS
WHEN ENTER KEY AND RESET
KEY ARE PRESSED IN SEQUENCE
DISPLAYED FOR 3 SECONDS
WHEN THE ENTER KEY IS
PRESSED
REDEFMSG.CDR
NOT A SELECTED
DEFAULT MESSAGE
DISPLAYED FOR 3 SECONDS WHEN
ENTER KEY AND RESET KEY ARE
PRESSED IN SEQUENCE
VAL IDDEFAULT
MESSAGE
NOT A DEFAULT
MESSAGE
RESET
RESETENTER
STORE
ENTER
A= 100 B= 100
C= 100 AMPS
Van = 120 Vbn = 120
Vcn = 120 V
FREQUENCY = 60.00 Hz
TIME: 12:00:00am
DATE: JAN 01 1996
Phone: 905-294-6222
www.GEmultilin.com
Location: A1 METERING CURRENTð
Location: A1 METERING VOLTAGEðò
Location: A1 METERING FREQUENCYðò
Location: A2 STATUS CLOCKðò
Location: A2 STATUS PROGRAMMABLE MESSAGEðò