GE PQMII - Value Keys; Data Entry Methods

3–6 PQMII POWER QUALITY METER – INSTRUCTION MANUAL
CHAPTER 3: OPERATION
FIGURE 3–3: Message Key Operation
3.3.7 Value Keys
Setpoint values are entered using the VA L U E keys. When a setpoint is displayed calling for
a yes/no response, each time a
VA L U E key is pressed, the “Yes” becomes a “No,” or the
“No” becomes a “Yes.” Similarly, for multiple choice selections, each time a
VA L U E key is
pressed, the next choice is displayed. When numeric values are displayed, each time
VALUE UP is pressed, the value increases by the step increment, up to the maximum. Hold
the key down to rapidly change the value.
3.3.8 Data Entry Methods
• Keypad Entry: Press the MENU key once to display the first page of setpoints Press the
MESSAGE RIGHT key to select successive setpoints pages. The page number and
page title appear on the second line. All setpoint page headers are numbered with an
‘S’ prefix. Actual value page headers are numbered with an ‘A’ prefix.
The messages are organized into logical subgroups within each Setpoints and Actual
Values page as shown below.
n SETPOINTS []w
S1 PQMII SETUP
DEFAULT MESSAGE TIME
1.0MINUTES
DISPLAYFILT ER
CONSTANT: 4
n PREFERENCES []w
SETPOINT ACCESS:
DISABLE
ENCRYPTEDSETPOINT
ACCESS CODE: 376
MESSAGE
MSGKEYOP.CDR
MENU
▲
▼
MESSAGE
Moves
forward within
a subgroup
Moves back
within a
subgroup
▲
MESSAGE
Moves forward to
the next menu level
Moves back to the
previous menu level
MESSAGE
MESSAGE
MENU
MESSAGE
▲
▼
MESSAGE
n SETPOINT []w
ACCESS
MESSAGE
MESSAGE
▲
▼
MESSAGE
n COM1 RS485 []w
SERIAL PORT
n SETPOINTS []w
S2 SYSTEMSETUP
▲
▼
MESSAGE
1. SETPOINTS []
Press
w
[]formorew
2. ACTUAL VALUES
Press []formorew