GE PQMII - 5.2.11 Programmable Message

CHAPTER 5: SETPOINTS
PQMII POWER QUALITY METER – INSTRUCTION MANUAL 5–17
5.2.11 Programmable Message
PATH: SETPOINTS Ö S1 PQMII SETUP ÖØ PROGRAMMABLE MESSAGE
A 40-character message can be programmed using the keypad, or via a serial port using
the EnerVista PQMII Setup Software. An example of writing a new message over the
existing one is shown below:
TIPS:
• The setpoint access must be enabled in order to alter the characters.
• To skip over a character press the
ENTER key.
• If a character is entered incorrectly, press the
ENTER key repeatedly until the
cursor returns to the position of the error, and re-enter the character.
•See 3.4 Default Messages for details on selecting this message as a default
message
A copy of this message is displayed in actual values page
A2 STATUS ÖØ PROGRAMMABLE
MESSAGE.
 PROGRAMMABLE [Z]
MESSAGE
PHONE: 905-294-6222
www.GEmultilin.com
Range: 40 alphanumeric characters
n PROGRAMMABLE
n MESSAGE
PHONE: 905-294-6222
GEindustrial.com
NEW SETPOINT
STORED
P ONE: 905-294-6222H
GEindustrial.com
NEW SETPOINT
STORED
STORE
Displayed for 3 seconds when
ENTER key pressed
Displayed for 3 seconds when
ENTER key pressed
USE THE VALUE
KEYS TO SELECT
THE UNDERLINED
QUANTITIES
VALUE
MESSAGE
ENTER
ENTER