– 35 –
Note: The front of the panel is held to the range
frame by 3 plastic grommets that engage 3 keyhole
slots placed along the inside front fl ange of the
panel.
14. Grasp the front and rear portion of the
side panel. Lift the side panel up and pull it
towards you, and then disengage the 3 plastic
grommets.
Plastic Grommet
Plastic Grommet
Grommet
Engaged (A)
Grommet
Disengaged (B)
A
B
To remove the left side panel on PS978:
It is necessary to remove the left side panel to
replace the bake element, hinge receiver, and upper
oven liner.
1. Remove the blower assembly. (See Blower
Assembly, follow steps 1-6.)
2. Remove the 1/4-in. hex-head screw located
near the front leveling leg.
3. Remove the six 1/4-in hex-head screws from the
top front of the control panel support.
Control Panel Support
(Continued next page)
To Next Page
Loading...
