ā 38 ā
Control Panel Support
11. Remove the two 1/4-in. hex-head screws from the
extension brace.
Extension Brace
8. Remove the cooling blower. (See Cooling Fan and
FAD (Fan Apparency Device).)
9. Remove the two 1/4-in hex-head screws from
the top front of the control panel support.
10. Remove the two 1/4-in hex-head screws that
attach the FAD to the top of the control panel
support.
FAD
(Continued next page)
12. Remove 1/4-in hex-head screw that attaches
the back of the extension brace to the range.
13. Carefully lift the right side of the control panel
support, slide the extension brace forward and
remove the extension brace from the range.
To Next Page
Loading...
