– 39 –
15. Remove the three 1/4-in hex-head screws from
the top of the side panel.
14. Remove the two 1/4-in hex-head screws from
the back of the side panel.
Note: The front of the panel is held to the range
frame by 3 plastic grommets that engage 3 keyhole
slots placed along the inside front fl ange of the
panel.
16. Grasp the front and rear portion of the
side panel. Lift the side panel up and pull it
towards you, and then disengage the 3 plastic
grommets.
Plastic Grommet
Plastic Grommet
Grommet
Engaged (A)
Grommet
Disengaged (B)
A
B
To remove the right side panel on PS978:
It is necessary to remove the right side panel to
replace the hinge receiver and upper oven liner.
Note: The procedure to remove the right side panel
on PS978 is similiar to removing the left side panel.
(See
Left Side Panel.)
To Next Page
Loading...
