GE RAREC1A - User Manual

Questions and Answers

C
Cody PhillipsAug 12, 2025
Why compressor does not turn on immediately on GE Thermostat?
- E
  Erika SawyerAug 12, 2025
  This is normal behavior. The GE Thermostat has a built-in 3-minute OFF timer to prevent the compressor from being turned off and immediately back on.
D
duranyolandaAug 16, 2025
What to do if the display is blank on GE RAREC1A Thermostat?
- C
  Crystal KingAug 16, 2025
  If the display is blank, check that 12VDC is present. The display will be blank when 12V is not present.
C
chapmandanielAug 19, 2025
What to do if all GE Thermostat buttons are non-responsive?
- G
  Gabriella SmithAug 20, 2025
  If all the thermostat buttons are non-responsive, verify that 12VDC is present. The unit will not operate when the voltage is below 10.5V.
D
David DavisAug 23, 2025
What to do if the fan runs continuously on GE Thermostat?
- R
  ramirezdavidAug 23, 2025
  Check the Fan Mode setting. If it is set to FAN ON, the fan will run continuously.
G
george39Aug 27, 2025
What to do if fan and compressor will not turn on GE RAREC1A Thermostat?
- C
  christopherfigueroaAug 27, 2025
  Verify that 115VAC is present.
A
anthonyholmesAug 30, 2025
Why fan does not turn on immediately on GE RAREC1A Thermostat?
- A
  April MartinezAug 31, 2025
  In Heat-Pump mode, if Auto Fan is selected, the fan will not turn ON until the compressor turns ON after the 3 minute OFF timer.
J
jonathanmorenoSep 4, 2025
What to do if the fan does not turn on, but the compressor does on GE Thermostat?
- K
  Karen DouglasSep 4, 2025
  With power removed, check that nothing is obstructing the fan blade and that it spins freely. Also, check the 5 amp Fuse on the board.
T
Tonya DaughertySep 7, 2025
What to do if room temperature does not match setpoint on GE RAREC1A Thermostat?
- D
  Derrick SteeleSep 7, 2025
  Verify proper installation. Ensure the thermostat is not on an exterior wall, in direct sunlight, or in an area affected by a vent or duct.