GE RARMC Series - User Manual

Questions and Answers

C
Cindy AndersonSep 8, 2025
Why compressor does not turn on immediately on GE RARMC Thermostat?
- G
  Gina RobertsSep 8, 2025
  This is normal behavior. The GE Thermostat has a built-in 3-minute OFF timer to prevent the compressor from being turned off and immediately back on.
L
laurenhernandezAug 23, 2025
Why does my GE RARMC Thermostat fan run continuously?
- R
  Robert MurphyAug 23, 2025
  If the fan on your GE Thermostat runs continuously, check the fan setting. If the fan setting is set to 'ON', the fan will run continuously.
M
maria91Aug 25, 2025
Why does my GE RARMC fan not turn on immediately?
- T
  Terri SanchezAug 25, 2025
  If the fan on your GE Thermostat does not start immediately, this is normal. Some models have a minimum run time or time delay for the fan.
B
Billy ThomasAug 27, 2025
What to do if all GE RARMC buttons are inoperative?
- D
  Daniel RobertsAug 27, 2025
  If all the buttons on your GE Thermostat are inoperative, check that 12 VDC is present. The unit will not operate if 12 VDC is not present.
D
Deborah Hill MDAug 27, 2025
What to do if my GE RARMC Thermostat fan runs continuously?
- N
  nhallAug 27, 2025
  Check the Fan Mode setting on your GE Thermostat. If it is set to FAN ON, the fan is designed to run continuously.
S
sbondSep 22, 2025
What to do if room temperature does not match setpoint on GE RARMC Thermostat?
- D
  Diana MeyerSep 22, 2025
  Verify proper installation. Ensure the thermostat is not on an exterior wall, in direct sunlight, or in an area affected by a vent or duct.
G
Gregory StewartSep 16, 2025
Why fan does not turn on immediately on GE Thermostat?
- J
  Joseph MasonSep 16, 2025
  In Heat-Pump mode, if Auto Fan is selected, the fan will not turn ON until the compressor turns ON after the 3 minute OFF timer.
V
Valerie GreenSep 18, 2025
What to do if the fan does not turn on, but the compressor does on GE RARMC Thermostat?
- S
  Shannon GibbsSep 18, 2025
  With power removed, check that nothing is obstructing the fan blade and that it spins freely. Also, check the 5 amp Fuse on the board.
M
Melanie FordSep 7, 2025
Why room temperature does not match setpoint on GE RARMC?
- C
  Christopher MartinSep 7, 2025
  Verify proper installation of the thermostat, ensuring it's not on an exterior wall, in direct sunlight, or in an area affected by a vent or duct.
M
Matthew DuncanSep 4, 2025
Why does GE RARMC fan not turn on immediately?
- P
  Peter YoungSep 4, 2025
  In Heat-Pump mode, if Auto Fan is selected, the fan will not turn on until the compressor turns on after the 3-minute OFF timer.