D Front adjustment of the photocell position: Is accomplished via a level
located
on either side of the Film Holder Assembly. Five positions are available to suit patient
anatomy.
Note: An Up/Down button is located on the cover of the x-ray Tube/Housing Assembly.
Note: The optional Positioning Arm Up/Down Control Footswitches are located on the
right and left sides of the Senographe. See below for symbols meaning:
'623+96% '623+3/
'6+/4&**9&'6+/4&**
The Positioning Arm Control Buttons (
= in rotation,
= Up/Down) are located
at the top and bottom of each handrail. A protecting rim prevents patient access to the
buttons.
The Film Holder Assembly can travel 761 mm thru 1451 mm at a focal distance of 660 mm.
Rotation thru 360 degrees (+180 degrees thru -180 degrees) is available.
Note: I86 warning message will appear if the compression paddle is touched during
rotation of the positioning arm.
Refer to Chapter 3, Section 3 “Messages” for further explanation.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
