GE SENOGRAPHE DMR+

    
  

2–5 Control Console
See Illustration 1–7
The Control Console is the interface between the Operator and the
SENOGRAPHE DMR. It provides two functions:
D Receives operator commands.
D Displays replies and/or machine messages.
The Control Console consists of:

.! ' ' !!   (     ! / *((,
'    ! (  

'#   #

/# "  !!

/# " #   #
The following optional moveable accessory is available for the Console:

4 C! " 4 /(  &(
To use the Control Console, refer to Section 3.
Note: The symbol located on the control panel means that you must read the appropriate
chapter in the operator manual before taking any action.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).